You can buy these directly from the company. ![]() Recommended Sealers: We recommend using both V Seal’s 101 Penetrating Sealer and their TK6 NanoCoat Topical Sealer. Please inquire with our sales team for sealant recommendations. The purpose, area and other factors of the cement tile installation may affect which type of sealant in best for your tiles. Recommended products: In general, a penetrating or impregnating sealer is used, however not all provide the best results. It is important that any excess grout be removed with a damp cloth or sponge before it dries, Darker grout can stain the tile, so keeping the tiles clean while grouting is prudent.Apply the grout with a rubber float or a rubber squeegee, always moving diagonally across the joints.Dampen the tile installation with water before grouting.The grout should be fluid enough to completely fill the joints.Grout color should be equal to or lighter than the lightest color in the tile we recommend that you take a tile with you when choosing the grout color.Make sure that the sealant is completely dry before grouting.Rhodium Floors uses: Polyblend Non-Sanded Grout in white or off white Recommended products: Any non-sanded grout white or colored Please see the instructions for sealing on the following page. This will help prevent any staining from the grout and will add to the strength of an installation. If tiles require more cleaning, it is acceptable to lightly scrub the tiles with Oxyclean.Ĭement tiles must be sealed with one coat of sealer before grouting.If stains are present, soak a cloth in hydrogen peroxide and let sit on the stain for 15-20 minutes.If care was taken while installing the tiles, no other stains should exist. ![]() Lightly sand the tiles to remove any haze and dirt.Rhodium Floors uses: 220 grit sandpaper with water Recommended products: Water, 220 grit sandpaper, Hydrogen Peroxide or oxyclean Do not proceed with installation process until mortar has completely dried.Any residue or mortar left on the surface of the tile must be cleaned immediately to avoid staining.Cement tiles cannot be grinded after they are installed, so it is very important that they are perfectly leveled during installation. Using a rubber hammer to do this could damage the tile’s surface. Once laid level, press on the tiles using your hands.Lay the tiles with a 1/16-inch spacing between tiles.The tiles should be installed edge to edge (butt jointed) and laid on a perfectly leveled and clean surface.The tiles must be laid by hand and handled carefully to avoid damaging the edges.It is recommended that tiles be pulled from various boxes during installation to ensure a naturally rich installation.When installing a pattern we recommend installing the center design first, the borders, and lastly the field tile that will surround the center design.When using a pre-mixed adhesive the back of the tile should be cleaned lightly to ensure adhesion. When using thin-set mortar the back of the tile should be dampened. ![]() In either case use a high-notched comb trowel to spread the adhesive on the surface as well as on the back of the tile in order to achieve adequate adhesion. Tiles can be installed either with a pre-mixed adhesive, or with regular thin- set.Rhodium Floors uses: AcrylPro Ceramic Tile Adhesive Recommended products: Any thin-set mortar used for tile setting ![]() These instructions to ensure a durable and long lasting cement tile installation. Installing cement tile is a simple process, but it must be done with care in order to achieve the best results. Moroccan Tile Cement Installation Instructions
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |